How to address this warning: Contact status has experienced an abrupt . . . How to address this warning: Contact status has experienced an abrupt change? What happens is that each contact detection point has a “pinball region” associated with it One can control the size of this region by changing the pinball radius (Details view of Contact Region)
A Simple Adjustment to Fix a Contact Convergence Problem in Ansys . . . In this posting, I’ll talk about a contact convergence problem in Ansys Mechanical I’ll discuss steps we can take to identify the problem and overcome it, as well as a simple setting to make which dramatically helped in this case
Too Much Penetration at Contact Points – Ansys Message - FEA Tips ANSYS solver displays a variety of messages during the solution process Some of these are labelled as warning messages (such as contact status abruptly changing), while others are labelled as error messages (solution failed to converge)
Ansys - Mechanical - Contact tool - How to fix errors In static structural if i put contact tool to check contacts, there's many errors in red that say, bonded - far open I want to understand how to resolve this errors would be great if i could get some assistance on this enclosed a snip for reference hard to say without further information
What Does the Contact Tool Provide in Ansys Mechanical? When simulating a structural assembly, it is often most efficient to run the Contact Tool before running the analysis itself The Contact Tool runs in a fraction of the time required for the full structural analysis, and it warns you about any contact regions that are not working correctly